Powder Coating Tape Test

I usually test 2 3 surface areas on the specimen to determine an overall average. An acceptable result will show only a little of the powder coming off from the grid cuts. The crosshatch test is designed to test the adhesion of the powder coating to the metal substrate.

prestige air conditioning spring hill fl qupid vinci over the knee boots portable hydraulic chair pokemon ruby evolution chart price utah furniture price of matcha green tea latte at starbucks powder coating vs spray painting cost portable brick oven pizza maker

Finish Coatings System Adhesion And Test Methods Resources Defelsko

An Introduction To Powder Coating Quality Control Testing

Proper Testing Of A Powder Coat Finish Products Finishing

Cross Hatch Adhesion Testers

Tape Test For Evaluating Coating Adhesion

High Temperature Powder Coating Tape Keep Powder Out Of Unwanted Areas Eastwood Youtube

It s performed by cutting a crosshatched grid pattern into the coating all the way down to the substrate.

Powder coating tape test.

Generally the pass fail is graded on a progressive scale. 8 3 for test panels report the substrate employed the type of coating the method of cure and the environmental conditions at the time of testing. Tapes and adhesion testing for powder coating. 5 chemical resistance test astm d1308 place approximately 10 drops of test solvent consisting of 95 by weight toluene and 5 by weight methal ethyl keytone on the surface of the coating.

A special pressure sensitive tape is then applied to the crosshatched area and then removed quickly at close to a 180 degree angle. Pressure sensitive tape is applied and removed over cuts made in the coating. If this is not possible the test method should be used only for ranking a series of test coatings. The test is performed by making a series of cuts through the coating.

Apply any sticky tape then remove slowly. No coating removal is a good pass. Note 4 permacel p99 tape previously identiﬁed as suitable for this purpose was withdrawn from manufacture in july 2009. Allow to stand for 30 seconds.

As with most people trying to obtain results using the tape test my frustration was with the variation in the method more so than the tape. The most common areas to test for basic powder coating functionality are. There are two variants of this test. Last angle the tape at approximately 45 degrees then firmly holding the end of the tape give it a fast pull off the surface.

Results should be no lifting of the cured powder between scribe lines. In its simplest version a piece of adhesive tape is pressed against the paint film and the resistance to and degree of film removal observed when the tape is pulled off. The x cut tape test and the cross hatch tape test. 8 4 if the adhesion strength of the tape has been determined in accordance with test methods d 1000 or d 3330 report the results with the adhesion rating s.

That area is then judged to see if any paint was removed from the cross sections that were cut. If a square or two of coating is removed adhesion can be. The x cut tape test is primarily intended for use at job sites. Pull the tape off aggressively and look at the tape and the part.

By far the most prevalent test for evaluating coating adhesion is the tape and peel test which has been used since the 1930 s. Essential that tape from the same batch be used when tests are to be run in different laboratories. This test is easy and a must for checking powder coating adhesion. On metal substrates a more formal version of the knife test is the tape test.

Pressed down real good and then the tape is removed. The more paint that is removed the worse the overall grade would be.