Choose boards that are 1 inch 2 5 cm thick so they fit easily onto the ends of your rafters.
Rake boards roof.
Wood is the most commonly used material for a fascia.
Roof rake boards are installed in different widths based on the surface being covered.
For example a large 1 4 or 1 6 rake board works when there isn t an eave extending out to an overhang on the gable end.
The ends of your rafters are usually either 6 or 8 inches 15 or 20 cm tall so boards that are 8 or 10 inches 20 or 25 cm tall will work best.
Rake plates of one by 2 inches often cover the exposed top edge of the liner when there is also a ledge at the end of the gable.
Use larger rake boards such as 1 by 4 inch and 1 by 6 inch when there isn t an eave overhang on the gable end.
Purpose of a rake board.
Use larger rake plates such as 1 by 4 inches and 1 by 6 inches when there is an infinity ledge at the end of the gable.
One by 2 inch rake boards often cover the exposed top edge of the siding when there also is an eave overhang on the gable end.
Raking on a gable roof can easily be replaced with hardie boards.
The roof rake plates are installed in different widths depending on the surface being covered.
On a gable roof the rake board or fascia is the slanting edge at the end wall of the house.
Contact h s roofing and gutter to replace the rotten rake boards into beautiful new ones.
You can buy boards for your fascia from a hardware or home improvement store.
Before the roof sheathing goes on the open framing provides easy access for attaching the return blocking and the nailers for the rake soffit.
The purpose of the rake board is simply to prevent rain from running behind the siding or to cover the top edge of brick if it s a brick home.
These boards vary in size.
For example six inches up for every 12 inches across.
Rakes are always miter joined at the ridge of your roof.
People also call it a raking cornice or sloping cornice.
Rake board gives your roof and the eaves the finished look you want to really enhance the ambiance of the exterior appearance.
There are many terms to identify the different parts of your roof and the rake board is one of them.
You measure this as a rise and run equation such as 6 12 where the rake angle rises six units in 12 units of run.
This is the name given to the board that you place on along the slope of the roof of your home.
A rake board covers the top edge of siding or it covers the soffit if there is an overhang on the end of the gable.
The last pieces to go in were nailing blocks above the ledger for the back of the return and at the bottom edge of the soffit for attaching the rake 20.